Colour LCD 128x128 Carrier
Ref: TB-SF-1005
The Colour Nokia screen ipre installed on a handy break out board enabling simple connection to the display
Stop trying to solder the 0.5mm pitch Color LCD connector! Just snap the Color LCD onto this carrier board and start playing! The Color LCD Carrier Board requires only 3.3V and boosts this voltage to drive the LED backlight at 6.5V. The multiple solder jumpers allow the end user to get complete access to the LCD connector if needed, but the basic connection is only 6 pins:
+Vin (3.3V)
CS (Chip Select)
SCLK (Serial Clock)
SDATA (Serial Data)
RST (Reset)
GND (Ground)
Carrier board comes fully assembled and tested but does not include the Color LCD screen.
Special Note:
The LCD screens are sensitive to electrical noise on the Vdsp supply line (Pin 6 on LCD). This line provides power for the LCD itself while Vdig supplies power to the screens controller and interface logic. This breakout board allows several different power configurations using jumpers. By default the board takes a single 3.3 volt input to power the booster circuit and both Vdsp and Vdig. This configuration causes large amounts of noise on Vdsp that can cause the screen to flicker randomly. For best results use a separate 3.3 volt supply for Vdsp. If a separate regulated 3.3 volt supply is not available for Vdsp, try a 100uF capacitor between Vdsp and GND which should provide acceptable performance.
Price:
£25.00
(£28.75 Including VAT at 15%)
Quantity:
|
